Shop

This Motorcycle Paint Kit includes everything you need to paint your motorcycle Cu-29. From the primer , basecoat, and topcoats tothe optional prep and masking materials each item has been specially put together for you in one all-inclusive bundle. You simply choose the desired color, project type, finish (Matte, Satin or Gloss), and optional add-ons. Then we handle the rest. Doesnt get easier than this!

About this color:is an epic Alpha Custom Color with the best aspects of candy and custom colors! This is a “Candy Pearl” basecoat BUT covers significantly better than the traditional candy pearl. This has 5x the amount of pearl which we formulated to give much better coverage without sacrificing the candy effect. This is a copper with gold candy undertones which really brings a beautiful depth and vibrancy to this color!

Details About This Kit: This is for good condition motorcycle only. You will need to get high build primer in addition to this kit if you are refinishing / smoothing out curb rash.

This is only to be used over powder coat, paint, or aluminum frames. NOT CHROME.

*Spraying over chrome can cause poor adhesion. Some customers have good luck with sand blasting the chrome then using adhesion promoter, but do this at your our risk*

Steps to using the kit:

1. Take off all parts you don’t want to mask or paint (usually best to strip completely to frame only)
2. Wash your motorcycle very well to get the brake dust off. We recommend using iron x soap + a scrubber mitt
3. Dry your motorcycle & then wipe down with the included wax & grease remover (avoid getting on the tires to avoid drying the rubber out)
4. Scuff the entire surface you are planning to paint with the included scuff pad & paste until the entire finish is flat & “scratched up”.
5. Rinse with warm water and dry the frame with a clean rag & compressed air.
6. Mask any parts you don’t want to get paint on (especially important with bushings, gaskets, etc) and any other areas you don’t want to get overspray on. Make sure no masking is touching the surface of the frame to avoid bridging.
7. Wipe the entire surface with a clean microfiber & the included wax & grease remover
8. Shake the primer cans according to the label. Then spray 1 light coat on the entire surface of the frame wait 5 mins, then spray 1 medium wet coat on the surface.
9. Wait 1hr after the frame 100% dry to the touch
10. Shake basecoat cans according to the label. Then spray 2-4 basecoats on the frame (wait 10 mins or until flashed in between coats) until the desired effect & color is achieved.
11. Wait 30 mins after the basecoat is 100% dry to the touch
12. Spray 2-4 wet coats or clearcoat with 10 mins or until fingerprinting (check masking) in between coats
13. Unmask after a minimum of 30mins.
14. Let dry 8hrs before handling them

Includes all materials needed to paint your motorcycle frame

One Motorcycle Kit properly covers most frames (small to xl)

Step by step video guides available

TSS experts are available and ready to help via chat or phone!